Boat Operation Guide -- 9.9 hsp Johnson Motor (trouble shooting below)
- Outfit proper size lifejackets for ALL people and at least 1 throwable (seat cushion), see woodshed on west side of the lodge for all lifejacket needs. (All children 10 yrs and younger must wear a flotation vest according to Minnesota)
- Make sure your motorized boat has at least 1 oar, 1 anchor tied to bow of boat, 4 mooring lines –(2 starboard {right} and 2 port {left} both fore & aft)
- Some type of bilging device to remove rain or wave water should be in boat at all times. (1 gal. plastic bottle, sponge, or both)
- Check fuel , (note: this boat is equipped with a 3.3 gal tank & should be filled to 3 gal mark with oil/gas mixture to prevent spillage due to waves)
- Fuel cap should be vented or cracked, and both ends of fuel lines should be secured to tank & motor. Squeeze the primer bulb on the fuel line to make sure it is firm & full of fuel.
- Before starting, double check motor is not buried in lake weeds or mud. (Lower left blk lever locks/unlocks motors’ ability to tilt. (lever down is unlocked/up is locked) in down position you can pull motor up or down until it clicks in place. Warning : Locked position should be chosen before engaging motor to full throttle or motor may porpoise.
- To Start: Make sure black shift lever is in neutral position,(pushed back is reverse, middle position is neutral, and pulled toward you is forward) . Pull Choke, and pull cord. If engine is firing on its own, push the choke in after letting engine warm-up for a minute. Note: If air temperature is above 80 deg. F , choking the engine will not be necessary, and may actually flood engine. Engine should always start within the first 3 pulls. If not – see troubleshooting guide.
- With engine running, make sure water is “peeing” from starboard rear of engine. If not, push red kill switch immediately, and find a CWC employee to help you.
- Before engaging transmission, make sure the 2 mooring lines are disengaged and engine path is free of weeds. If not; you may have to push or row the boat away from the dock until a clear path is available before engaging motor. Throttle must be at the lowest position before attempting the reverse or forward gears!
- Slowly back boat away from dock and turn to engage forward motion as soon as possible. (Propellers are not designed to go quickly in reverse and easily tangle in weeds.)
- When motor is clear of weeds, engage tilt lock (black lever under left side of engine cowl) and engage throttle to desired level of thrust.
- When returning to dock, make sure motor will not be dragging through the mud and weeds, slowly edge up to one side of dock or other and tie (moor) 2 lines from boat to dock. Note: Please do not moor your boat to the top of either T – dock(sides are ok) to let people fish and to prevent damage to the boat from quickly arising winds or storms. If stormy weather is predicted , make sure to have boat facing toward lake,(motor toward shore) to prevent waves from swamping and sinking the boat.
Troubleshooting Motor Guide
Engine won’t start –
- Check both fuel connections, fuel primer should be hard
- Make sure red lanyard cord is attached to the red button (kill switch)
- If you smell gas or see it in the water behind the motor, the engine is flooded. Push in choke, turn throttle to lowest idle, & continue pulling start cord until excess fuel has been evacuated from carb. (Extreme cases may have to let motor set for 10 minutes before reattempting to start)
Engine sputters –
- Make sure choke is pushed in
- Make sure fuel lines are connected
Engine runs at full throttle but boat doesn’t move-
- Is anchor in water?
- Stop engine, lift, and check for weeds.
A whistle is located at the end of the red lanyard cord for emergencies. If cell phone is available you may call the resort @ (218)652-3111 or Ryan @ (218) 252-7769 for help.
NOTE: This boat & motor is not designed to pull/tow any tubes, skis, kneeboards, etc. and should not be used as such unless emergencies dictate it!